|
Premium Paver Sealer is a solvent, based sealer with a lustrous sheen. It has a very high glass transition point providing excellent resistance to tire marking, lifting, scratching and marring in hot climates. It provides a deep rich look to intensify any concrete finish and offers a high resistance to acid, oil, grease, and mildew as well as stains from organic matter..
The following materials are suitable for the designed use of Premium Paver Sealer; imprinted or stamped concrete, brick, stone, interlocking pavers, exposed aggregate, stucco, keystone, and industrial concrete.
Premium Paver Sealer can also be applied to these surfaces; pool decks, patios, entrances, sidewalks, driveways, tennis and shuffle board courts.
|
|
1 Clean Surface:
Remove Dirt, oil, grease with general purpose cleaner and degreaser. Wet surface and scrub in cleansing solution using hot water and a hard bristled brush or broom. Allow solution to set 10 to 15 minutes then rinse thoroughly.
2 Acid Etch:
To open the pores of the surface for maximum sealer penetration, acid to 3 parts water. Use plastic sprinkler can and scrub with broom. Rinse the surface and LET DRY COMPLETELY UNINTERUPTED FOR 24 HOURS before sealing.
3 First Coat:
Before applying first coat make certain surfaces is completely dry. Apply evenly with roller or airless sprayer. Wait until dry before applying second coat.
4 Second Coat:
Apply evenly and use full strength PAVER SEALER. In some cases due to surface porosity, additional coats may be required. Tack free in one hour. FOOT TRAFFIC IN 24 HOURS.
Note: Applying two coats is at the discretion of the installer. If using only one coat, apply paver sealer generously.
Resource: paversupplywarehouse.com
|
|
